How to communicate 1756 PLC with CANOpen DCS system

yang1216

Member
Y
Join Date
Jun 2009
Location
BeiJing
Posts
84
Our 1756 PLC have to communicate with the existed DCS system, but the customer told us that the DCS system only supported CANOpen fieldbus.
So, is there any communication module supported CANOpen network from Rockwell or other vendors? And if the DCS only supported CAN 2.0A, is there any solutions for us?
Thanks very much.
 

Similar Topics

P
Communicate ABB CI 840 IO Master with Allen Bradley 1756 - L75 PLC
Hi Guys, Here I have Started to work on some difficult task I hope I will get some solution here. I wanted to communicate ABB CI 840 IO Master...
Replies
2
Views
902
prakasha
P
P
Communicate ABB CI840 IO Module with Rockwell 1756-L75 PLC
Hi Guys, Here I have Started to work on some difficult task I hope I will get some solution here. I wanted to communicate ABB CI 840 IO Master...
Replies
0
Views
577
prakasha
P
A
Communicate to PLC 5 using 1756-DHRIO.
I have communicated to a PLC 5 via Ethernet network by using 1756-DHRIO from peer communication port DH+. But is it possible to communicate to a...
Replies
2
Views
2,163
alhasas96
A
L
Allen-Bradley 1756-L55 controller to communicate with MVI56-MCM
can we use Allen-Bradley 1756-L55 controller to communicate with MVI56-MCM Modbus communication module
Replies
4
Views
1,944
lrahman
L
E
Can't get communicate with 1756-CNBR
Dear All, I have problem to communicate with 1756-CNBR neither using 1784-PCC nor via ControlLogix5000 back plane. The module LED shown steady RED...
Replies
8
Views
2,566
daba
D
Back
Top Bottom