I am a newbie trying PSIM and am facing difficulty with a counter in the Batch program. I observe that there is significance in the order of the rungs in this case.
Please see this picture
The pump 1 (O:101) trigger flow meter I:105
The pump 2 (O:102) trigger flow meter I:106
Both flow meters are used to increment a counter C1
Pump 1 works till counter = 35, and afterwards pump 2 works
Now when I give counter before inputs (Program 1 in figure) counter is activated by I:105 but not activated by I:106. It just stops at 35.
When I give counter after inputs (Program 2 in figure) counter is activated by I:106 also.
Why?
Please see this picture
The pump 1 (O:101) trigger flow meter I:105
The pump 2 (O:102) trigger flow meter I:106
Both flow meters are used to increment a counter C1
Pump 1 works till counter = 35, and afterwards pump 2 works
Now when I give counter before inputs (Program 1 in figure) counter is activated by I:105 but not activated by I:106. It just stops at 35.
When I give counter after inputs (Program 2 in figure) counter is activated by I:106 also.
Why?