I have connected to my TI525 cpu, can see the program, but when I try to save PLC (aux function 60) I get the fault message: Function not avalible - load-only version.
Looking up the fault in the programming book: "The selected write function is not avalible because this mode of TISOFT is read-only......"
So I have a read only version of the software? Is there a way of not making it read only or do I need to find some new software?
Looking up the fault in the programming book: "The selected write function is not avalible because this mode of TISOFT is read-only......"
So I have a read only version of the software? Is there a way of not making it read only or do I need to find some new software?