Comunication problems to S7-200 through microwin
- Thread starter R101ET
- Start date
geniusintraining
Lifetime Supporting Member + Moderator
Try this
http://www.youtube.com/watch?v=Ud6CfBzye8E
I think it would be the same as the cable you have, if not it still may help
http://www.youtube.com/watch?v=Ud6CfBzye8E
I think it would be the same as the cable you have, if not it still may help
Similar Topics
Hello Everyone.
I had this problem. PLC S7 200 CPU 226 has a DB 9 RS-485 PORT and PanelView C300 has the same PORT But only 4 connector called [...
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Hello all.
I have a future project planned with a leibinger jet3up inkjet printer that I will have to send the print details to the printer via...
Good evening partners, ist my first question on forum, i hope receive any answer.
I need make a cable DH485 for communicate an Panel View 550...
Hello guys,
I have compact Guardlogix L30ERMS with IP address set to 192.168.1.11
a Panelview compact 600 with IP 192.168.1.12 and a 1734 AENT...
