I'm looking to use a net620 (RS232 to Ethernet) bridge to connect the channel 0 port of a compactlogix L32 to a Ethernet network ring to get data from a Controllogix. I quickly connected this yesterday before the long weekend but was having problems getting the configuration of the net620 to take. However,I did finally get this but ran out of time to complete setup. So I was wondering how others have done a setup similar to this? And if you could share how you setup your messaging instructions between the two controllers? Thanks in advance.
Net620 ethernet bridge
- Thread starter Mtech
- Start date
Similar Topics
Hello guys i'm working with an s7 1200 plc with an ET 200S expansion module. The problem is that i can't find the plc when searching in the...
Hello
I have a s7-1200 and I would like to read the tags present in this controller with my controllogix controller. The two controllers don't use...
Can we use a Simotion D455 ethernet port x127 as a gate, to access S7-1500 plc Tia Portal program ?
In the Simatic manager, we used Netpro to do...
So I have a sort of unique situation where I'm wanting to run a PF755 from the IO and over ethernet. Of course, this comes with it's own set of...
Hi all,
My ethernet port on my laptop recently broke and I was hoping to just use a usb-c dongle in the mean time to go live on my PLC until I...