help for stepper replacement

JASHOK

Member
J
Join Date
Nov 2005
Location
mumbai
Posts
1
hi
i need help to replace an schneider Berger lahr Stepper motor and drive with new Schneider lexium series servo drive and controller
the textile machine of Nuovo Pignone
the controller is MP986 and the stepper Drive is WDP5-228
feel free to clear any point
regards
 

Similar Topics

M
Stepper motor help/can I open .s7p files with Tia Portal v17?
Hi all, I am starting a project with motion control and currently have a few stepper motors that I want to get working with a S7-1200 CPU. The...
2
Replies
15
Views
4,193
marko18
M
S
Stepper motor help
STP-DRV-6575, RSlogix500, Stepper Module 1746-hstp1 So, here is my dilemma. I was just recently thrown this project at work that I was supposed...
Replies
2
Views
1,298
Sevenfins
S
E
Stepper Motor Emulate code help :-|
Hi all. I have an application to apply but i have been using RSlogix Emulate to pre-code my application and would like if someone correct me if i...
Replies
4
Views
1,637
nmurray
N
K
I need help with simple stepper motor code.
Question 1: I am still new to this - I also might be asking for too much. - but i need help using Ladder Logic to run (rod style actuator motor)...
Replies
6
Views
1,672
khaledgenidy
K
A
Seek help!! Programming the stepper motor
Hello, I am new To using Plc. I found difficulty in programming a stepper motor with mitsubishi FX3u plc by using GX developer. I have learnt that...
Replies
9
Views
2,747
Ronnie Sullivan
R
Back
Top Bottom