Reading FX2N-4AD data from Q2 via CC link

ptuamyim

Member
P
Join Date
Feb 2013
Location
Bangkok
Posts
1
Greeting,
I have some problem about reading FX2N-4AD data. Below is my connection
Q2PLC - Connect to FX3U with CC Link
In 1st node, I have FX2N-4AD connect to FX3U as child.

Address of Remote Register in Q was set to W1000 and W1800. Same as Remote X which setted to X1000. Remote X is fine its working well. But I can not get data from Remote Register. Any recommendation on this.
 

Similar Topics

M
HELP PLZ!!Reading Analogue channel of FX2N-4AD
Hi friends, I want to read voltage in the range of +10/-10V using analogue unit Mitsubishi FX2N-4AD with FX1N-40MR. I am using the GX IEC...
Replies
14
Views
4,923
mian
M
M
Reading from the Analogue Channel FX2N-4AD
Hi everyone, I am using the analogue unit FX2N-4AD with FX1N-40MR of Mitsubishi FX Series PLC.I am using GX IEC Developer. I need to calculate the...
Replies
1
Views
1,566
Dariusch
D
X
Reading Memory/Variables - MELSEC FX2N
I would like to learn more about PLC's, particularly the MELSEC FX2N. My first question is, is there free software available for reading...
Replies
0
Views
1,570
Xei
X
P
Reading analog input in FX2N Mitsubishi PLC
Hi All, I am trying to collect data from an analog switch using AD module in a FX2N series PLC. I have attached my small code that I am using to...
Replies
14
Views
20,372
idabagusngurahw
I
A
reading data from siemens controller (profinet) to ethernet/IP controller
Hello I have a s7-1200 and I would like to read the tags present in this controller with my controllogix controller. The two controllers don't use...
Replies
5
Views
141
bkottaras
B
Back
Top Bottom