RS5000 startup: Always runs "install" for RSNetworx

Anyone seen or cured this one? I recently installed V21 of RSNetworx for Dnet and since then, every time RS5000 is started, RSNetwork goes through a setup routine for half a minute or so complete with popup and progress bar, screen icons are refreshed and then RS5000 wakes up. Is there perhaps a little file somewhere that needs deleting?

Thanks.

I have not found a cure yet, but wanted to let you know that you are not the only who has this problem. The installer also runs for me when I start RS500.

I have had this occur, reinstall your RSL5000 (RS500) software.

Thanks, I'll try it.

If it gives you the option, do a "Repair" install.

OG