silbar.fernandes
Member
could somebody give me a rough guide to configure and program a 168adi analog card for a level sensor
q68adi card mitsubishi
- Thread starter silbar.fernandes
- Start date
phongnhatdo
Member
hi.
you can use to software GXconfigurator-AD, it integated in tool Unility.it can be config detail function of module.
Beside we can config with tool parameter in GX-developer, it allow setting parameters of module such as voltage, current( 0-20mA, 4-20mA).
you can use to software GXconfigurator-AD, it integated in tool Unility.it can be config detail function of module.
Beside we can config with tool parameter in GX-developer, it allow setting parameters of module such as voltage, current( 0-20mA, 4-20mA).
silbar.fernandes
Member
OP
thanks mate will try that
Similar Topics
Has anybody used this before and can you help with the following;
1. How do you set or change the resolution, I've been thru' the AI card user...
Hi,
We have been facing a issue with SCADAPack 474. Configuration is like below.
RTU 474 + 6103 PS + 5606 IO Mix Module + 5414 DI Module
Only...
I have a 120V relay, 120V DI card and a analog input. I was wanting to know if i could put a 24V DI and well as a 120V DI card on the same plc...
Hi everyone.
I'm trying to read values from a Loadcell with a 2080-TC card.
I know the 2080-TC is a thermocouple card but it reads millivolts that...
Omron AD081-V1 Analog Input Card
Offset & Gain Adjustment
Entering Adjustment Mode
1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...