recycled_mind
Member
Dear Plc experts,
Can anybody share the code for DB1 to enable on-board analog I/o and interrupt I/o? I've been programming fb250 but cannot see process data in XA. I only see XA= 390B which is configure to be stored in FW130.
I've try to vary the 0-10v input but nothing changed.
Hope anybody can guide, what should I do. Or if I miss something here.
Thanks,
Alex Senagan
Philippines
Can anybody share the code for DB1 to enable on-board analog I/o and interrupt I/o? I've been programming fb250 but cannot see process data in XA. I only see XA= 390B which is configure to be stored in FW130.
I've try to vary the 0-10v input but nothing changed.
Hope anybody can guide, what should I do. Or if I miss something here.
Thanks,
Alex Senagan
Philippines