Prosoft module with ABB drive

dbh6

Lifetime Supporting Member
dbh6
Join Date
Jan 2013
Location
Central, NJ
Posts
552
Hello everyone,

I have a prosoft module MVI56E-MCM on a control logix rack that will be communicating over modbus 485 to a ABB ACH550-UH HVAC Drive. I was wondering if anyone has this type of setup and got the data working??
 

Similar Topics

A
Heartbeat from B&R RIO to Control Logix: Modbus TCP via Prosoft MNETC module
Hi all, I have an application where there is a Control Logix PLC connecting to a B&R remote I/O station over Modbus TCP via a prosoft MNETC...
Replies
5
Views
1,910
ASF
A
B
ControlLogix & Prosoft module vs ModBus AOI
I've worked on a handful of projects that relied on a Prosoft module for Modbus comms with other systems (older PLCs, boilers, chillers, much...
Replies
5
Views
2,154
Brew Chip
B
T
ProSoft MVI56MCM Module - Dev Address
I am trying to set up a Dev address in a ProSoft MCM module. This module is acting as the master. The Modbus of the slave address is 7566 in a...
Replies
0
Views
1,273
Tesla2016
T
C
Prosoft Module Profile issues - Logix Designer
I'm running into an error I haven't seen before with regards to adding a Prosoft 1756-MVI56E-MCM card into a rack of an offline project. When I...
Replies
4
Views
2,433
Crocodile Tears
C
G
prosoft 3100MCM module error
I have AB PLC 05/30 redundancy system,the system has actuator gate which communicating using prosoft module(cat no. 3100MCM) now on prosoft...
Replies
0
Views
1,439
Ganeshjangam
G
Back
Top Bottom