AB DTAM micro

Is there a simple way to determine on the screen where a # goes? It's wired into a 5/03 and when I can pull up recipes menu I can enter 1--100. So from the DTAM screen can I find what file it goes into without changing anything?

Thanks Terry

It's unlikely without viewing the program in the DTAM Micro. For more information and free software go to Spectrum Controls. The page has the manual and - under "2707-NP" the software (may require a registration). I think you'll be able to upload the current program from the display. (Simple cable diagrams are in the manual.)

Terry I put my hands last time on a DTAM more than 10 years ago, however I used to use a software called Putty, I still have it. Send me a pm with your email.

Viewing the PLC program - if it's properly documented - would give some clues as to destination. Also viewing the PLC while also online with the HMI to see which registers change.