I am working on a two robot turn table welding cell. I am trying to set up my devicenet network. I have my sensor inputs routed through a Turck sensor block on node 30 and 31. I am able to see the inputs active from node 31 but not from node 30. I am using an Omron CJ1M-CPU13 and a devicenet master unit CJ1W-DRM21. Any help anyone could give is very much appreciated. Thank you so much.
Not seeing all the nodes on my devicenet network.
- Thread starter jstone
- Start date
Similar Topics
Hello everyone, this is my first post on this forum but it's helped me in the past and hopefully it will help me now. I'm trying to get a first...
Hi!
Small question. I have a customer currently that is reporting an issue of 2 different panelviews running the same application connecting to...
I have a currently running PLC (Control Logix) with a computer connected running FTV ME Station for the HMI. Everything is connected via ethernet...
Hello,
I am trying to setup communication to a Panelview 800 HMI Part No. 2711R-T4T in Connected Components Workbench 12.00
I am using a...
Hi, thanks in advance all for reading. I'm automating my lathe and I am using my AB CompactLogix L45 PLC as control. I followed the basic steps...
