hi. I am using s7 1500 and I have to built pressure regulator with proportional magnetic valve. I want to use PID Compact block. How to set its gain parameter ? I have no knowledge of it. Its gain parameter is not setting up. I am always having error. Kind regards
s7-1500 PID Compact tuning
- Thread starter hammad
- Start date
Similar Topics
Hello all,
I have been ask to convert a program from RSLogix500 to TIA V15.1 (S7-1500). The program uses a few PID loops. From RS500 the...
I am using a micrologix 1500 plc to control a hydraulic extrusuion ram with a proportional control valve 0-10vdc. I am also using a temposonics...
dear all:
we have a automated vehicle which runs on a magnetic tape.
we are taking analog input [0 to 10] volts from a reader
this has a...
Dear All,
I am trying to setup PID logic in micrologix 1500 LRP. but plc is going in fault mode showing major error as " Invalid value is being...
First,i apologize to everyone for my stupid english!
Lately,i am suffering from the PID founction of A-B's PLC which is MicroLogix1500.
This...