sdanielracing
Member
Hi to everyone well this is my question.
I have a set up of 3 panelwiew enabled PC's (let's call them A B C) using FactoryTalk View SE , each of this is running its project on the LOCAL mode from a .CLI file, but it can also be run on FTVStudio as a local project meaning project is stored there itself and it runs its project client so the operators do their job.
And I got a computer (PC1) on the same network, this computer also has FactoryTalk View SE installed. So I want to be able to run (view and tap) the HMI projects hosted on A B C. All I want is to have the HMI clients on both ends (PC1, and A B or C) so that I can supervise (and maybe edit) all three PanelViews from my office.
Could someone help me out? A step by step guide would be awesome. I could even let you remote access if you were to help me out.
Thanks in advance.
EDIT: Forgot to tell all computers ABC and PC1 are on the same network.
I have a set up of 3 panelwiew enabled PC's (let's call them A B C) using FactoryTalk View SE , each of this is running its project on the LOCAL mode from a .CLI file, but it can also be run on FTVStudio as a local project meaning project is stored there itself and it runs its project client so the operators do their job.
And I got a computer (PC1) on the same network, this computer also has FactoryTalk View SE installed. So I want to be able to run (view and tap) the HMI projects hosted on A B C. All I want is to have the HMI clients on both ends (PC1, and A B or C) so that I can supervise (and maybe edit) all three PanelViews from my office.
Could someone help me out? A step by step guide would be awesome. I could even let you remote access if you were to help me out.
Thanks in advance.
EDIT: Forgot to tell all computers ABC and PC1 are on the same network.
Last edited: