ProSoft RTU-5/03 Processor with 16 K RAM

Dear All,

Im trying to configure the running PLC as a slave to DCS. I need to sent few analog and digital signal for monitoring only.

http://www.prosoft-technology.com/v...lication/826d0a2079b42ab7fab8636dcbdfc1d3.pdf

Using the above manual i made the setting.
Im trying to use holding registers 40001 to 40005 to send data.

As im doing to configure this first time in SLC500
Please help me which destination register i have to use for moving data (ex M100:1 to M100:5)

Seyed,

It's been a few weeks so I suspect you got this resolved. If not, I suggest you contact ProSoft..

[email protected]