Schneider Zelio SR2 A101FU serial cable

meatbeast

Member
Join Date
Jul 2015
Location
brighton, UK
Posts
5
Hi,

Just unboxed our Schneider Zelio SR2 A101FU , loaded zeliosoft 2 v4.5 and I cant for the life of me talk to the PLC, I get error DC46_10
ive tried 2 computers, 1 with a serial port and 1 with a usb to serial converter, can the smart relay talk straight after power on or do I have to enable communications? does anybody know the board rate or port settings? i've tried using hyperterminal to talk to it and I am not seeing anything?

any suggestions would be gratefully received!
Kindest regards,
John
 
Hi, please first of all download the suitable driver for your communication cable. your cable com port should be get detected in communication ports of your PC/Laptop.
once your cable is ready, in your zelio soft software. go to transfer menu, there define the buad rate and com port in communication settings.
after that TRANSFER (MODULE TO PC).
it will start reading your plc program .
Thanks .
Take care.
 

Similar Topics

Hello everyone, I currently trying to get a Schneider Zelio SR2 B121BD programmable relay to communicate with ZelioSoft 2 v5.2.0.0. The PLR...
Replies
3
Views
1,532
Hi. I am, in fact, not an specialist in PLC's but, in my work we remotely access a gear 500 kilometers away and we have observed, after some...
Replies
4
Views
2,502
I'm not familiar with this software at all. I have most of the ladder logic working except for the fact that I need two pumps to alternate, or...
Replies
6
Views
4,308
Hi, I am working on schneiders smart relay called zelio.
Replies
12
Views
3,524
Hi Please I have zeilo smart relay #SR2A201BD but I don't have it's programming cable. Can I use any general usb/rs232 converter? Or need...
Replies
1
Views
33
Back
Top Bottom