Hi,
I'm not sure if this idea have a wrong approach :
Currently programming a Micrologix 1400B:
Because this is a stand-alone equipment, what I want is to config modbus/tcp putting some registers available to any other with the right config retrieving.
Example: assign B9:1/1 to coil 00001. This with the idea to create a generic config manual and modbus/tcp table for the clients.
I'm not sure if this idea have a wrong approach :
Currently programming a Micrologix 1400B:
Because this is a stand-alone equipment, what I want is to config modbus/tcp putting some registers available to any other with the right config retrieving.
Example: assign B9:1/1 to coil 00001. This with the idea to create a generic config manual and modbus/tcp table for the clients.