My new company has some old Cutler Hammer PLCs in use. More specifically numerous D50's and a couple of D300's. Upgrading is on the horizon but for the moment one particular D300 is becoming a royal pain.
The biggest concern I have right now is a major failure. I can get a used CPU but lack the C/H software. I had "winGPC v2.50" on my laptop but it was corrupted and unusable.
So my questions are....
Is winGPC available anywhere ?
Is any other software compatible with the D50/300 ?
Thanks in advance
The biggest concern I have right now is a major failure. I can get a used CPU but lack the C/H software. I had "winGPC v2.50" on my laptop but it was corrupted and unusable.
So my questions are....
Is winGPC available anywhere ?
Is any other software compatible with the D50/300 ?
Thanks in advance