I'm trying to setup the Ethernet port on a new 319 3-PN/DP.
I have the PG/PC Interface setup on "Ethernet Connection (2) I219-LM TCPIP Auto.1. I also have in the properties IE-PG Access Tab "Assign IP addresses unique to project" selected.*
Again just using the Siemens PG unit I can ping the PLC,* compare blocks, and go online with the program. If I select in the IE-PG Access Tab "Do not assign IP addresses automatically" I lose all communication.
Using my standard laptop I cannot ping the PLC. The PLC is an update from a 315 2-DP to a 319 3-PN/DP.
Thanks
-Randy
I have the PG/PC Interface setup on "Ethernet Connection (2) I219-LM TCPIP Auto.1. I also have in the properties IE-PG Access Tab "Assign IP addresses unique to project" selected.*
Again just using the Siemens PG unit I can ping the PLC,* compare blocks, and go online with the program. If I select in the IE-PG Access Tab "Do not assign IP addresses automatically" I lose all communication.
Using my standard laptop I cannot ping the PLC. The PLC is an update from a 315 2-DP to a 319 3-PN/DP.
Thanks
-Randy