vinay.chawla
Member
I've had a few strange experiences with Kinetix 5500 drives. Sharing the most recent one.
I have a setup of 14 axes with 3 on Kinetix 6500 and rest of 11 on Kinetix 5500 (in two groups).
One of my colleagues accidentally left the digital encoder feedback cable disconnected from one of the Kinetix 5500 drive. Ideally I must have been getting faults related to motor detection on that particular drive. Instead, all drives including the Kinetix 6500 group got stuck into "configuring" stage. Studio application also didn't help identifying the real reason behind it.
Finally, I troubleshooted this issue by unscheduling the each and every axis one by one and found which drive was faulty.
Finally we corrected the problem with same address.
Anyone else with similar experience here?
I have a setup of 14 axes with 3 on Kinetix 6500 and rest of 11 on Kinetix 5500 (in two groups).
One of my colleagues accidentally left the digital encoder feedback cable disconnected from one of the Kinetix 5500 drive. Ideally I must have been getting faults related to motor detection on that particular drive. Instead, all drives including the Kinetix 6500 group got stuck into "configuring" stage. Studio application also didn't help identifying the real reason behind it.
Finally, I troubleshooted this issue by unscheduling the each and every axis one by one and found which drive was faulty.
Finally we corrected the problem with same address.
Anyone else with similar experience here?