adam_lhadi
Member
HI everyone as a beginner i have been working with the time delay interrupt to understand how it works
the SRT_DINT instruction starts the counting with a negative edge in EN input
when disactivating the interrupt with CAN_DINT instruction the the counting stops but it give an error code 16#80A0 (Time-delay interrupt has not started.) rather than 16#0000 why is that
i didn't totally understand the use of the DIS_AIRT and EN_AIRT instruction and what's the difference between DIS_AIRT and CAN_DINT
when creating a time delay interrupt OB what's his cycle time (how long he last) what the limitations when putting a code inside of it like putting a timer
thanks for all please correct me if am wrong
kind regards
the SRT_DINT instruction starts the counting with a negative edge in EN input
when disactivating the interrupt with CAN_DINT instruction the the counting stops but it give an error code 16#80A0 (Time-delay interrupt has not started.) rather than 16#0000 why is that
i didn't totally understand the use of the DIS_AIRT and EN_AIRT instruction and what's the difference between DIS_AIRT and CAN_DINT
when creating a time delay interrupt OB what's his cycle time (how long he last) what the limitations when putting a code inside of it like putting a timer
thanks for all please correct me if am wrong
kind regards
Last edited: