KingPresident
Member
I have 2 configured PLC's that send and receive MSG's.
PLC 1
Set to CIP Data table Read
MSG Source is msgFROMplc2.dint[0]
MSG Dest is InputBuffer.dint[0]
I can send a value from PLC2, AND I can see it show up in PLC 1 at msgFROMplc2.dint[0], but the MSG will not push it to InputBuffer.dint[0]
However, I can use a MOV to move the value from msgFROMplc2.dint[0] to InputBuffer.dint[0] and it works, but I would think that it should be moved by the MSG instruction, not my additional MOV.
Clear as mud?
Is this normal, and if not, what am I doing wrong?
I am enabling and resetting every 1 second.
PLC 1
Set to CIP Data table Read
MSG Source is msgFROMplc2.dint[0]
MSG Dest is InputBuffer.dint[0]
I can send a value from PLC2, AND I can see it show up in PLC 1 at msgFROMplc2.dint[0], but the MSG will not push it to InputBuffer.dint[0]
However, I can use a MOV to move the value from msgFROMplc2.dint[0] to InputBuffer.dint[0] and it works, but I would think that it should be moved by the MSG instruction, not my additional MOV.
Clear as mud?
Is this normal, and if not, what am I doing wrong?
I am enabling and resetting every 1 second.