Hi there.
I have a problem on a Q series mitsubishi QooUCPU.
Here the ladder go.
Ld sm403
Out t11 k2
Ld m200 and not l110w
Ld m503
Ld not m504
And t11
Out rst L1100
While power turn off and on back, the rst output will always
On before the timer contact on.(i try adding timer count to
50 so i can monitor)
Only if i put sm401 between the output and the contact
Then only can stop the rst on.
Is there any way(beside putting sm401) to let rst dont
On so fast. And only on after all those contact on.like usual
?
Tq
I have a problem on a Q series mitsubishi QooUCPU.
Here the ladder go.
Ld sm403
Out t11 k2
Ld m200 and not l110w
Ld m503
Ld not m504
And t11
Out rst L1100
While power turn off and on back, the rst output will always
On before the timer contact on.(i try adding timer count to
50 so i can monitor)
Only if i put sm401 between the output and the contact
Then only can stop the rst on.
Is there any way(beside putting sm401) to let rst dont
On so fast. And only on after all those contact on.like usual
?
Tq