Ok, thanks for that prediction, that would be my next question, but that is not really
a problems because of which I started this thread. I've noticed one thing that I couldn't
explain and that is rejecting symbolic names by some blocks. I said Move instruction, but
I was wrong, I'm sorry, I assumed that is the case for Move instr. too, but it's not.
So, what exactly is a problem?
Let's take FC 105 (Scale) for example.
1. I've created new project and create entry in Symbol tabel just like on picture Case_1_sybmol_table
and I give name "Analog_input" for PIW288
2. In OB1 I place FC105 on rung and when I enter input and output data, FC105 reject to accept PIW288
(picture Case1_ob1.jpg), then I tried to enter sym. name "Analog_input" in field IN but result is same
just like on picture Case1_symbolic.jpg
3. To solve this problem, I've deleted name "Analog_input" from symbol table and now I have table just like
on picture Case2_symolic_table
4. Then on input IN on FC I enter PIW 288, and FC accept it, just like on picture Case2_OB1.
After every change in symbolic table I saved it so that's not causing this problem.
In short problem is that FC is not accepting PIW 288 nor it's symbolic name, but when symbolic name
is deleted FC accept this address PIW 288
Can you check this to make sure is this the case with your software?
If you're willing I could send this Test project to check it yourself.