We manufacture machines with lots of variable parameter set points, mostly DINT's but some BOOL.
The issue we have is if a software/project update is pushed out, the technicians have to record every parameter value of the specific machine, do the update, then manipulate the values to back match previous setpoints.
This occurs because most updates are tested on separate machines which setpoints may vary from the machine being updated.
While not a huge issue, it does open up potential for major human error, causing the tech headaches or call backs before they even get to the airport.
Does anyone have a good way of managing this?
Thanks,
The issue we have is if a software/project update is pushed out, the technicians have to record every parameter value of the specific machine, do the update, then manipulate the values to back match previous setpoints.
This occurs because most updates are tested on separate machines which setpoints may vary from the machine being updated.
While not a huge issue, it does open up potential for major human error, causing the tech headaches or call backs before they even get to the airport.
Does anyone have a good way of managing this?
Thanks,