LStewart
Member
Can someone give a link for instructions on how to set up a PID in a program? At least something that will point me in the correct direction. I don't have the users manual for my 1746-NIO4V
You too?...LStewart said:I am converting 3 25 year old molding machines with 5TIs to slc 5/04.
The 4LTC allows you that option as well, but ALSO has the outputs locally at the card. Download the manual from the link I provided.504bloke said:I suppose AB did it so you could use either a Digital card for TPO or an analogue card for Analogue controlled stacks
Yes, I read that part with interest. I'm not sure what it does differently to accomplish this. Does it just autotune all zones concurrently? I know that the first time I used autotune with the 4LTC, I did each zone separately. This did not give good results. The nozzle kept overshooting its setpoint. Once I tried autotuning all zones at the same time, it worked great (even though the nozzle zone took much longer to finish). I was amazed to see all zones maintaining their setpoints ±1°F, even while shooting plastic!504bloke said:It has some specific stuff programmed into the unit for Extruder barrels with zones adjacent to each other and has an autotune for the complete barrel or each seperate zone.
AD lists their distributor in the UK as www.lamonde.com504bloke said:Does the AD stuff get over the water to the UK ?