JFelectric
Member
ohh boy im in a bind.
currently on a shutdown right now and im burning the midnight oil because i cant get the customer's used PVP1500 to display my new .mer runtime.
it originally had a runtime on it from some 3rd party that it would boot to & display when powered on. it responded to touch so it was considered working.
i upgraded its firmware to 5.10. no errors, confirmed successful.
i built a project using FTViewStudio v10. and exported the runtime with 5.10 selected from the drop down.
the PVP15 now boots, i select the mer i want to run, and it gets to "display loading" message, then the display hangs there... im trying to wait it out right now but this is 20 min and still the same. i see the square frame open up but the display hangs on the loading message, and now my project buttons work fine. i can shut down, run config menu, operate a solenoid, solely because i touch the blank screen where i know the button should be.
heres the kicker: i have a PVP1000 with same 5.10 firmware. i download the same MER to it and it boots no problem,PVPs is that the 1000 has like 4x the memory.. but on the 1000 usage window shows a ton of unused RAM on the, and used ram is less than the total available on the 1500.
got any ideas?
currently on a shutdown right now and im burning the midnight oil because i cant get the customer's used PVP1500 to display my new .mer runtime.
it originally had a runtime on it from some 3rd party that it would boot to & display when powered on. it responded to touch so it was considered working.
i upgraded its firmware to 5.10. no errors, confirmed successful.
i built a project using FTViewStudio v10. and exported the runtime with 5.10 selected from the drop down.
the PVP15 now boots, i select the mer i want to run, and it gets to "display loading" message, then the display hangs there... im trying to wait it out right now but this is 20 min and still the same. i see the square frame open up but the display hangs on the loading message, and now my project buttons work fine. i can shut down, run config menu, operate a solenoid, solely because i touch the blank screen where i know the button should be.
heres the kicker: i have a PVP1000 with same 5.10 firmware. i download the same MER to it and it boots no problem,PVPs is that the 1000 has like 4x the memory.. but on the 1000 usage window shows a ton of unused RAM on the, and used ram is less than the total available on the 1500.
got any ideas?