hii
i have a servo controler mp2300 from Yaskawa.
i want to connact with cimplicity hmi through modbus tcp protocol.
i open mudbus tcp request from mp2300 and configer the cimplicity hmi to work with modbus tcp/ip .
the problem is that when i config the point on cimplicity i get error massage -"point found to be invalid "
when i use address 0XXXX or 0XXXXX
4XXXX or 4XXXXX
i will appreciate if some body can help me
eli
i have a servo controler mp2300 from Yaskawa.
i want to connact with cimplicity hmi through modbus tcp protocol.
i open mudbus tcp request from mp2300 and configer the cimplicity hmi to work with modbus tcp/ip .
the problem is that when i config the point on cimplicity i get error massage -"point found to be invalid "
when i use address 0XXXX or 0XXXXX
4XXXX or 4XXXXX
i will appreciate if some body can help me
eli