Timeismoney08
Member
I have a question regarding some calculations I'm doing...
I find that most of our motors are around 1/2HP, so for some applications we may install one and gear it down to fit our needs.
What I have a question regarding, is how much over on torque or speed is acceptable. I can run the numbers sometimes and get 100% speed match, but way over on torque, or 100% on torque and high on speed. I would average the two and go in the middle of each as long as the application will work with it.
Obviously this is a improper motor selected for the application, I'm just curious what is considered normal values.
Thank you!
I find that most of our motors are around 1/2HP, so for some applications we may install one and gear it down to fit our needs.
What I have a question regarding, is how much over on torque or speed is acceptable. I can run the numbers sometimes and get 100% speed match, but way over on torque, or 100% on torque and high on speed. I would average the two and go in the middle of each as long as the application will work with it.
Obviously this is a improper motor selected for the application, I'm just curious what is considered normal values.
Thank you!