Cognex 130C failure

tarik1978

Member
T
Join Date
Mar 2010
Location
casablanca
Posts
716
We bought a new vision sensor Cognex 130C
It was powred ok the first time from a 24 vdc power supply as in the manual.
Next time it would'nt power at all we checked the voltage and the polarity good, the overcurrent led of the power supply was on we checked the breakout cable good we checked the resistance between pins +24vdc and ground in the camera connector we found a short
Did this happen to anyone?
 

Similar Topics

E
Cognex dataman 280 barcode reader input to rslogix 5000
Hello, I am trying to read a barcode scanner input using a cognex dataman 280 barcode reader, store it another string, the compare with another...
Replies
1
Views
79
Emmabod
E
croakus
Re-purpose a Cognex Sensorview monitor
We finally replaced our Cognex Checker with an IV-3 and I'm wondering if can replace the s/w in the monitor with anything else. I haven't been...
Replies
0
Views
108
croakus
croakus
J
RSLogix 5000 and Cognex In-Sight Explorer 5.9 - Will not Read/Write data
Thank you for any and all responses/help. I have an RSLogix 5000 v20 and a Cognex In-Sight v5.9 spreadsheet (8502P). I can not figure out how to...
Replies
0
Views
145
JEM
J
H
Siemens S7-1200 communication with Cognex 2800
Which signals do I have to use to get data from camera. For example camera detects a defect and sends signal to controller. Power cable: CCB-PWRIO-05
Replies
1
Views
228
Puddle
P
B
Cognex- How to record images with graphics
Good People of PLCTALK. I am trying to understand the pass-fail on one of our product lines. I was able to record the Cognex images on the...
Replies
2
Views
248
bdauliya
B
Back
Top Bottom