phuz
Member
I don't believe I ever touched a basic module, but I'm doing a project that involves one communicating with SEW Eurodrives. We are adding new drives to the line, so I need to give them new addresses. Setting them on the drive, itself, seems straightforward. I need some assistance in what utilities I need to set up the basic module, as I see it's set in the module itself and not the program. Is there software I can use to set this module up for these additional addresses?
Currently, the module is in slot 4, and they use a timer to cycle through the drive speeds, I believe. So they set O:4.2 to an integer value equal to what I believe is the drive's address, and they set O:4.3 to a value representing speed. I'm guessing I can't just add the "new" addresses at the end of the current ones because that would be too easy.
Currently, the module is in slot 4, and they use a timer to cycle through the drive speeds, I believe. So they set O:4.2 to an integer value equal to what I believe is the drive's address, and they set O:4.3 to a value representing speed. I'm guessing I can't just add the "new" addresses at the end of the current ones because that would be too easy.
Last edited: