PhysicalAxisFault at Kinetix 6000

mike3475

Member
M
Join Date
Feb 2013
Location
brooklyn ,NY
Posts
334
Hi,Guys:
we got issue with Kinetix6000 servo drive with E06 (HardOverTravel Fault),
I saw "AS_Axis06.PhysicalAxisFault" showing 1 at monitor tag of Studio 5000 when Kinetix6000 servo drive shuts off with E06.
should I change the physical travel limits for this servo drive to make its travel range a little bigger?
thanks!
 
You should not cross the hard limit unless something has gone horribly wrong, the axis travel is badly designed, or the sensors are in the wrong position.
 

Similar Topics

F
Troubleshooting Excessive Velocity Error/PhysicalAxisFault
Hi All, I have a 2097-V31PR0-LM Kinetix 350 and a TLY-A110T-Hxx2 servo. It is a new setup and I've commissioned the drive: Scaling, hookup tests...
Replies
12
Views
21,385
JTCat
J
E
Kinetix 5100 - Velocity Loop
Hi guys, I have the first Kinetix 5100 in my facilities. I already configure the movement in Speed Mode, I am sending the Analog signal from my...
Replies
1
Views
51
Peter Nachtwey
Peter Nachtwey
W
Brake Control Kinetix 5500
Hi all, I am upgrading a couple of 2094-BC01-M01 servos with 2198-H015-ERS. The original code uses MSG instructions to control (release, engage...
Replies
2
Views
83
DarrylR
D
E
Tunning Kinetix 5100
Hello all I was trying to autotune a Kinetix 5100, I got an encoder fault and it says to check the wiring. I remove the 24 volts from drive to...
Replies
0
Views
53
ELGC
E
T
Kinetix 5500 issue
Hello everybody, I have Kinetix 5500 (2198-H040-ERS). I'm having issue with this drive. (I believe it's the drive/Kinetix and need confirmation)...
Replies
0
Views
62
tjntjntjn
T
Back
Top Bottom