Slwagner73
Lifetime Supporting Member
So, just to start, I am not an engineer, but a sort-of self taught programmer.
And I am familiar with RSLogix-500, but I am just learning Studio-5000.
Here goes my question:
I would like to use a Panelview 800 HMI with a CompactLogix 1769-L27ERM PLC and a 1734-AENTR Remote I-O.
I used CCW to program the HMI, and I was sure to use the correct name for the PLC, and added the "192.168.0.2,1,0" per the manual.
I can see the HMI in RSLinks, and I can see the Remote I-O there also, but in the program, I get the stupid caution symbol for each of these devices.
And neither of them will do anything.
I get numerous errors every time I boot the HMI, and following the directions from the Rockwell site gets me nowhere.
Are these just not compatible?
Thanks for your time:
Scott
And I am familiar with RSLogix-500, but I am just learning Studio-5000.
Here goes my question:
I would like to use a Panelview 800 HMI with a CompactLogix 1769-L27ERM PLC and a 1734-AENTR Remote I-O.
I used CCW to program the HMI, and I was sure to use the correct name for the PLC, and added the "192.168.0.2,1,0" per the manual.
I can see the HMI in RSLinks, and I can see the Remote I-O there also, but in the program, I get the stupid caution symbol for each of these devices.
And neither of them will do anything.
I get numerous errors every time I boot the HMI, and following the directions from the Rockwell site gets me nowhere.
Are these just not compatible?
Thanks for your time:
Scott