Hi everybody,
May be a generic question for you advanced programmers, but I do not know how to break it down any further.
When any of you are moving or copying numeric data from PLC to HMI are you using numeric (INT or DINT) or do you mostly just use string files?
Some examples i deal with mostly are, cycle counters, MDIs, (where operator sets a number and the machine makes a descision based on that number. ) numeric part numbers, etc..
I am basically usING counters, moves and copies to set data clear data and transfer data.
Thanks alot!
May be a generic question for you advanced programmers, but I do not know how to break it down any further.
When any of you are moving or copying numeric data from PLC to HMI are you using numeric (INT or DINT) or do you mostly just use string files?
Some examples i deal with mostly are, cycle counters, MDIs, (where operator sets a number and the machine makes a descision based on that number. ) numeric part numbers, etc..
I am basically usING counters, moves and copies to set data clear data and transfer data.
Thanks alot!