ryano
Member
I cannot create a runtime file (.mer) using Factory Talk. It worked fine a couple weeks ago. Each time I try to create a runtime file, it starts out looking normal (saving displays, etc.), but then it stalls when saving the last display.
The only error message I get is a popup that says "Unable to save the project runtime file C:\Users\...... \Projectname.mer"
The progress bar always stops at the same place ("Compression" looks done and starting on "Rdmdata\Digit.RET") (See attached screenshot)
I am not having any problems with RSLogix5000 or RSLinx, so I think my activations are good.
I may have installed RSLogix Emulate since the last time I created a runtime file... could that interfere somehow? I am running FactoryTalk View Studio ME 6.10.10 (CPR 9 SR 4)
Any help will be greatly appreciated!
Thanks!
Ryan
The only error message I get is a popup that says "Unable to save the project runtime file C:\Users\...... \Projectname.mer"
The progress bar always stops at the same place ("Compression" looks done and starting on "Rdmdata\Digit.RET") (See attached screenshot)
I am not having any problems with RSLogix5000 or RSLinx, so I think my activations are good.
I may have installed RSLogix Emulate since the last time I created a runtime file... could that interfere somehow? I am running FactoryTalk View Studio ME 6.10.10 (CPR 9 SR 4)
Any help will be greatly appreciated!
Thanks!
Ryan