Dears
Once again need your support. I am starting on a simocode.After factory reset, I am trying to make some changes or reconfiguring the simocode but after this I am not able to download the new configuration to device with Simocode ES software.
It says " parameter change not possible currently" Motor may be running.
This simocode is on my workshop not connected to motor. After google , I found some remedies like , Motor ON feedback in protection control. I made it permanent 0 . Even the remote mode is disabled. But no use.
Can someone explain the possibility.
Once again need your support. I am starting on a simocode.After factory reset, I am trying to make some changes or reconfiguring the simocode but after this I am not able to download the new configuration to device with Simocode ES software.
It says " parameter change not possible currently" Motor may be running.
This simocode is on my workshop not connected to motor. After google , I found some remedies like , Motor ON feedback in protection control. I made it permanent 0 . Even the remote mode is disabled. But no use.
Can someone explain the possibility.