MrRobot2you
Member
Hi all,
I read an old thread on here about sliding mode control (SMC) and how it should be considered more in temperature applications as apposed to PI control. I was wondering if anyone has put any effort into implementing this and how it compares to a PID controller. I assume the time to get the controller coded and working would be a lot longer than just placing a PID block.
Basically just looking for discussion on the comparison between PID and SMC control. If it is worth the effort, pros and cons and the likes.
New here and loving the community and threads.
:site:
I read an old thread on here about sliding mode control (SMC) and how it should be considered more in temperature applications as apposed to PI control. I was wondering if anyone has put any effort into implementing this and how it compares to a PID controller. I assume the time to get the controller coded and working would be a lot longer than just placing a PID block.
Basically just looking for discussion on the comparison between PID and SMC control. If it is worth the effort, pros and cons and the likes.
New here and loving the community and threads.
:site: