psychosunshine
Member
I have a Panelmate 1785T with the AB accelerator option card, talking DH+ to my SLC 5/04. The error light comes on immediately after powering up the HMI. There is no DH+ communications.
I don't have the optional AB driver disk for the Panelmate software. But, I don't need that just to transfer the project, do I?
Also, what are the pinouts on the serial cable to the Panelmate serial ports. Does it tranfer with either COM1 or COM2, or does it matter which port that I use?
I don't have the optional AB driver disk for the Panelmate software. But, I don't need that just to transfer the project, do I?
Also, what are the pinouts on the serial cable to the Panelmate serial ports. Does it tranfer with either COM1 or COM2, or does it matter which port that I use?