panic mode
Member
Hi everyone,
I've run into a problem with Yaskawa servo drive and need help asap (any help is more than welcome)
We are trying to get this going before Monday but the time is running out and I can't get hold
of my contacts before Monday.
The drive is FSP-02A, it is wired per manual and it looks normal, passes all checks etc.
but it doesn't switch to Run mode when /S_ON is active. I was checking if the signals are ok
by using I/O monitoring - Un005 (inputs) and Un006 (outputs). Everything is ok, no alarms,
setting inputs is correctly indicated by drive and so on. Pos and Neg Overtravel are wired
(and correctly indicated by drive) but servo doesn't provide Ready signal and display
never switches to RUN.
I can use software to go online with the drive. I checked parameters and inputs assigment everything looks fine. I tried mapping signals in parameters to another inputs, forcing it etc. but no luck.
I've run into a problem with Yaskawa servo drive and need help asap (any help is more than welcome)
We are trying to get this going before Monday but the time is running out and I can't get hold
of my contacts before Monday.
The drive is FSP-02A, it is wired per manual and it looks normal, passes all checks etc.
but it doesn't switch to Run mode when /S_ON is active. I was checking if the signals are ok
by using I/O monitoring - Un005 (inputs) and Un006 (outputs). Everything is ok, no alarms,
setting inputs is correctly indicated by drive and so on. Pos and Neg Overtravel are wired
(and correctly indicated by drive) but servo doesn't provide Ready signal and display
never switches to RUN.
I can use software to go online with the drive. I checked parameters and inputs assigment everything looks fine. I tried mapping signals in parameters to another inputs, forcing it etc. but no luck.