toughguy19
Member
I am just beginning my programming and I have written several smaller programs for fun. I have gotten my machine manufacturers to send me the programs that we use in our shop. I was wondering if there is a way to convert them so that I can practice on them. That is, without going all in and buying the software just yet. For AB I just have RSLogix Micro Starter Lite at the moment.
Here is the message from the vendor "One of the lines has a SLC processor. The other line is a compactlogix processor. We can send copies of either program files, but you will have to have software to open them. The SLC line requires RSLogix 500. The compactlogix line requires Studio 5000 v21."
I now have both of the actual files. I would also take it in PDF if that is all that is available. At least then I can follow and see the logic that our machines are doing.
Any help is always appreciated. Thank you to anyone just for taking the time to read this.
Here is the message from the vendor "One of the lines has a SLC processor. The other line is a compactlogix processor. We can send copies of either program files, but you will have to have software to open them. The SLC line requires RSLogix 500. The compactlogix line requires Studio 5000 v21."
I now have both of the actual files. I would also take it in PDF if that is all that is available. At least then I can follow and see the logic that our machines are doing.
Any help is always appreciated. Thank you to anyone just for taking the time to read this.