Hi,
I need to set up a mixing station with 7 PF 525s. All I need is start, stop, forward, reverse and a fault message. Each mixer should be controlled by rpm, and this should also be displayed on the HMI (so I have to convert rpm to frequency at some point).
My question is whether or not the AOI is the right way to go. I'm relatively new to programming, and would like to implement the simplest solution for this, that is easiest to debug. The AOI has bits to switch between operator and program command, and I'm not sure if I can just remove all of these and use the remaining code?
Does anyone have examples they could share?
Thanks
I need to set up a mixing station with 7 PF 525s. All I need is start, stop, forward, reverse and a fault message. Each mixer should be controlled by rpm, and this should also be displayed on the HMI (so I have to convert rpm to frequency at some point).
My question is whether or not the AOI is the right way to go. I'm relatively new to programming, and would like to implement the simplest solution for this, that is easiest to debug. The AOI has bits to switch between operator and program command, and I'm not sure if I can just remove all of these and use the remaining code?
Does anyone have examples they could share?
Thanks