KETAN YADAV
Member
Make a 2 sec blinker using only one T-ON Timer.
Question
- Thread starter KETAN YADAV
- Start date
AshleyParr
Member
what have you tried?
cardosocea
Member
What duty cycle do you want with that?
rdrast
Lifetime Supporting Member
Compare.
Saffa
Member
Ok fine, I will. And it'll be the best 2 second flasher you've ever seen. Glorious. Magnificent.
hahahacardosocea
Member
That's actually a nice solution. Hadn't though of it myself.
DonBlack
Member
XIO timer.dn, timer preset 4 seconds....branch around timer with GRT timer.acc > 2 seconds,,, ote flash_bit
janner_10
Lifetime Supporting Member
Use a TON and reads bits of the .acc DINT
janner_10
Lifetime Supporting Member
AustralIan
Member
All of your answers use more than just a T-ON timer.
I can't think of how to do this without at least an XIO and an OTE. Maybe a GEQ.
I can't think of how to do this without at least an XIO and an OTE. Maybe a GEQ.
Similar Topics
I have a 120V relay, 120V DI card and a analog input. I was wanting to know if i could put a 24V DI and well as a 120V DI card on the same plc...
Hello again..trying something on an existing poorly written program and just wanted to double check something
system is an A-B MicroLogix 1200
In...
Good morning!
Let me start by saying, I am still learning about this type of HMI programming. I recently watched a video about recipes and how it...
I have some logic that I have written within a 5380 series controller that tracks the time an event is started, while the event is running an RTO...
I have an HMI 2711R - T4T Series B, and I want to know which PLCs, besides Micro 820, can communicate with it.