RioPLC
Member
Hello,
I am wondering how to connect between my CPUE05 port 2 (15pin) to a stepper motor that calls for B+,A-,GND connections.
What type of hardware will I need, I cannot seem to find any db15 male with a 2 wire breakout.
Thank you
I am wondering how to connect between my CPUE05 port 2 (15pin) to a stepper motor that calls for B+,A-,GND connections.
What type of hardware will I need, I cannot seem to find any db15 male with a 2 wire breakout.
Thank you