chrisreisinger79
Member
I have two SLC 5/05 PLCs which are displaying faulted under RSLogix (see attached picture). However, the faulted LED is not lit on either PLC nor does the program display a faulted state when connected online through RSlogix. If I attempt to download to either PLC, an error occurs and the PLC reverts to a DEFAULT state with no program. Program downloads are only possible through a direct DH485 connection.
Some more info:
They share a single common Ethernet connection back to the main hub. From that shared connection they are routed through an Ethernet switch to each PLC. I have tried a new common Ethernet connection, a new Ethernet switch, new Ethernet PLC connections, and new processors. There same error continues.
Some more info:
They share a single common Ethernet connection back to the main hub. From that shared connection they are routed through an Ethernet switch to each PLC. I have tried a new common Ethernet connection, a new Ethernet switch, new Ethernet PLC connections, and new processors. There same error continues.