I am communicating from a G315 to ControlLogix PLC.
I am sort of Phase 3 testing: application is mostly full featured and i have created lots of simulation logic to load the system.
I am seeing confusing problems: it appears that not all data is making it from PLC to G315.
Application communicates via EIP / imported tags. I imported tags into Crimson via L5X.
Is EIP via native tags the most sensible way to communicate with CLX processor? should I take the steps in TNOI17 (Crimson to CLS via EthernetIP)?
TNOI29 sez Crimson reads controller tags only. I am using program tags.. i assume this is an improvement over the older documented Crimson 2 environment?
any troubleshooting advice?
thx
gf
I am sort of Phase 3 testing: application is mostly full featured and i have created lots of simulation logic to load the system.
I am seeing confusing problems: it appears that not all data is making it from PLC to G315.
Application communicates via EIP / imported tags. I imported tags into Crimson via L5X.
Is EIP via native tags the most sensible way to communicate with CLX processor? should I take the steps in TNOI17 (Crimson to CLS via EthernetIP)?
TNOI29 sez Crimson reads controller tags only. I am using program tags.. i assume this is an improvement over the older documented Crimson 2 environment?
any troubleshooting advice?
thx
gf