busarider29
Lifetime Supporting Member
I have a legacy Pacific Scientific (now Kollmorgen) servo motor, part #R67BENH-R2-NS-NV-00. Attached is the motor data for this motor in pdf format that I received from Kollmorgen. I need to replace the drive and I want to go with something Allen Bradley. I have done some research on the Kinetix 6000 and found a a few of those units on Ebay that I could get. Would this drive work for this motor?? Also, I want to go Controllogix. What processor and card do I need (least expensive) for this? Also, I will have two servo motors to control with each running at constant speeds and acceration rates reaching 0-3000 rpm per second up to full motor RPM. I was looking at the L43 controllogix processor with a SERCOS card but not being an expert, I'm not sure if that is what I should go with or if it would work, etc. Any advice or expert opinions would be welcomed.
Thank you in advance,
Don
Thank you in advance,
Don