TimeFluxCap
Member
Hi all, question here about different RSlinx drivers running at the same time.
Here goes the story.
Have four different drivers configured on a laptop as follows
AB_DF1 DH+ Sta0 Com2 Running
AB_KT-1 DH+ Sta2 Socket2 Running
AB_MASTR-1 DF1 Sta1 Com1 Running
AB_PIC-1 DH485 Sta0 Com2 Stopped
These drivers have been pre-configured and all setup so in the heat of battle you dont have to waste time doing so. Problem is, if I want to use my PIC box and use the AB_PIC-1 driver, RSlinx tells me to stop the other driver using com2. How do I do this? The way I do it at the moment is to delete that driver. I would think there is an easier way.
Regards
TFC
Here goes the story.
Have four different drivers configured on a laptop as follows
AB_DF1 DH+ Sta0 Com2 Running
AB_KT-1 DH+ Sta2 Socket2 Running
AB_MASTR-1 DF1 Sta1 Com1 Running
AB_PIC-1 DH485 Sta0 Com2 Stopped
These drivers have been pre-configured and all setup so in the heat of battle you dont have to waste time doing so. Problem is, if I want to use my PIC box and use the AB_PIC-1 driver, RSlinx tells me to stop the other driver using com2. How do I do this? The way I do it at the moment is to delete that driver. I would think there is an easier way.
Regards
TFC