Not PLC but I know there are guys out there that can help with this.
We are replacing the controls on an old Tree CNC mill with a Yaskawa spindle motor and drive.
Old drive # VS626 MT3
Motor info:
UAASKA 04CA1
3.7/2.2 Kw
rpm 1500 / 8000
200 volt max
32 / 23 amps
An electrician here wired the motor direct to a 208 v line and it stalled and took out the breaker. Apparently it saturated and the current went ballistic.
The motor has since been checked by a motor shop.
What are we going to need for a drive (sensorless vector), and how do we set the parameters?
Any other observations would be welcome.
Thanks
We are replacing the controls on an old Tree CNC mill with a Yaskawa spindle motor and drive.
Old drive # VS626 MT3
Motor info:
UAASKA 04CA1
3.7/2.2 Kw
rpm 1500 / 8000
200 volt max
32 / 23 amps
An electrician here wired the motor direct to a 208 v line and it stalled and took out the breaker. Apparently it saturated and the current went ballistic.
The motor has since been checked by a motor shop.
What are we going to need for a drive (sensorless vector), and how do we set the parameters?
Any other observations would be welcome.
Thanks