AEI Service
Member
Hello
I need some help / advice.
Short version need help with a GE FANUC IC693CPU323. Connected to a GE FANUC Datapanel Model 160. Would like recommendation on a repair shop that should know this unit and be able to check if there is a program in it and if not down load one I have that is supposed to be the correct one. At a reasonable cost. I would buy the soft ware and cables if available, unless it is a complicated unit to connect to, I have basic knowledge (real basic) I have a 486 laptop to work on old telemecanique TSX Nano units, I have downloaded and edited and uploaded and it worked.
longer version
I have a machine (I am the 3rd person they called) One said the power supply was bad, so owner bought one online did not work bought 2rd on did not work, now he calls me.
Found no power to power supply loose wire. Fix plc light up the touch screen still not working, trace back to a fuse. Touch screen now working. The screen seems to have info but will not do anything. Touch pad does work but when touched to start the screen changes but nothing happens, The other person said the PLC battery went dead so the memory/program was gone. Now I have seen the touch screen loose programming but never a PLC. The battery tested good.
I work in the printing industry and work on a lot of equipment with plc’s, I know the basics but really hard to take courses to learn programming when there are so many out there and all seem a little different. Plus, the software and the cables to talk to them and the computers,
other parts
FANUC IC693PWR321 Power supply
HORNER ELECTRIC HE693SNP940 Not sure what this is in the last slot.
I need some help / advice.
Short version need help with a GE FANUC IC693CPU323. Connected to a GE FANUC Datapanel Model 160. Would like recommendation on a repair shop that should know this unit and be able to check if there is a program in it and if not down load one I have that is supposed to be the correct one. At a reasonable cost. I would buy the soft ware and cables if available, unless it is a complicated unit to connect to, I have basic knowledge (real basic) I have a 486 laptop to work on old telemecanique TSX Nano units, I have downloaded and edited and uploaded and it worked.
longer version
I have a machine (I am the 3rd person they called) One said the power supply was bad, so owner bought one online did not work bought 2rd on did not work, now he calls me.
Found no power to power supply loose wire. Fix plc light up the touch screen still not working, trace back to a fuse. Touch screen now working. The screen seems to have info but will not do anything. Touch pad does work but when touched to start the screen changes but nothing happens, The other person said the PLC battery went dead so the memory/program was gone. Now I have seen the touch screen loose programming but never a PLC. The battery tested good.
I work in the printing industry and work on a lot of equipment with plc’s, I know the basics but really hard to take courses to learn programming when there are so many out there and all seem a little different. Plus, the software and the cables to talk to them and the computers,
other parts
FANUC IC693PWR321 Power supply
HORNER ELECTRIC HE693SNP940 Not sure what this is in the last slot.